Most ski jumps have either a wooden base or a metal or plastic foundation. The mats (22x22cm) are attached to the base using appropriate screws, with the connectors of the Watertrax gliding mats facing forward and to the right. The mats are pre-assembled into larger sections (approx. 1m x 2m) and then laid one after the other, starting from the takeoff ramp and working their way up to the starting point. Approximately 4 screws per square meter (about 20 screws) should be used. The steeper the slope, the more screws should be used to secure the mats.

To help jumpers orient themselves better when approaching the landing area, colored mats (e.g., red) should be laid out to the right and left of the approach lane. Colored markings should also be installed directly at the take-off edge to facilitate better take-off technique.

It is advisable, especially for Type 4 ski jumps, to install a water sprinkler system along the edge of the inrun track. Since very high temperatures are generated by friction at speeds of up to 80 km/h, water significantly reduces the friction between the skis and the plastic mats. The sprinkler system contributes substantially to the longevity of the mats and protects the ski bases. It is sufficient, for example, to lay a water hose along the right-hand side wall of the inrun, from the start to the takeoff ramp. A small nozzle should be screwed into the hose approximately every 3 meters. The water sprinkler system is easy to install with a significant positive effect. All large water jumps worldwide utilize the existing water from the pool or lake to irrigate the inrun track. A pump with a pressure of approximately 7 bar is sufficient. The required pump capacity depends on the height of the jump.